juvela
New member
-----
We recently took in a used T-80 macinadosatore and fitted it with a new burr set.
The motor runs a bit loud/rumbly & there appears to be some rotor wobble which looks & sounds more like bearing wear rather than shaft deformation.
The knives touch before a grind sufficient for espresso extraction can be achieved.
Wondering it it is feasible to replace motor bearings or if cost prohibitive.
Thank you for any suggestions.
-----
We recently took in a used T-80 macinadosatore and fitted it with a new burr set.
The motor runs a bit loud/rumbly & there appears to be some rotor wobble which looks & sounds more like bearing wear rather than shaft deformation.
The knives touch before a grind sufficient for espresso extraction can be achieved.
Wondering it it is feasible to replace motor bearings or if cost prohibitive.
Thank you for any suggestions.
-----
Last edited:
