jonawald
New member
Hi there. I'm new to this form. I came here with the hopes that somebody might be able to help me diagnose a problem on my Saeco Vienna Delux
I have some soldering experience and some experience with troubleshooting electronics. From what I have found so far the problem I'm experiencing might lead back to the microprocessor. Hopefully somebody with more experience with me can look this over and see if there is something else wrong with this machine.
The machine powers up and heats as normal. When I tap button to make coffee the grinder works, the brew group moves into position to brew but then no water flows. After a few seconds in this position the brew group goes to dump the grinds and the red light begins blinking.
I know that the pump works because I can get water and steam out of the steam wand. What gets the signal that the brew group is in position and is ready for water? I have verified that the microswitches work, but we already know that because the brew group cycles properly.
I found a schematic for this machine online but it is in German. My German is not great but good enough to make out most of this document. Maybe if I post this here, somebody can look it over for me and tell me which parts of the board are involved in calling for water once the brew group is in position.
Jonathan
I have some soldering experience and some experience with troubleshooting electronics. From what I have found so far the problem I'm experiencing might lead back to the microprocessor. Hopefully somebody with more experience with me can look this over and see if there is something else wrong with this machine.
The machine powers up and heats as normal. When I tap button to make coffee the grinder works, the brew group moves into position to brew but then no water flows. After a few seconds in this position the brew group goes to dump the grinds and the red light begins blinking.
I know that the pump works because I can get water and steam out of the steam wand. What gets the signal that the brew group is in position and is ready for water? I have verified that the microswitches work, but we already know that because the brew group cycles properly.
I found a schematic for this machine online but it is in German. My German is not great but good enough to make out most of this document. Maybe if I post this here, somebody can look it over for me and tell me which parts of the board are involved in calling for water once the brew group is in position.
Jonathan